Current location：
hot product
hot news
message
detail
Brief introduction:
F-200G series of high heat insulation sleeve has the advantages of heavy weight, accurate size, low thermal conductivity, high bending strength, high refractoriness, not easy moisture absorption, etc., widely used in high pressure molding lines. Easy to use and stable and consistent feeding performance.
Effect:
1, effectively solve the casting loose, shrinkage hole and other defects.
2, the process yield is very high.
3, high fever
4, very high strength
5, suitable for point feeding, grinding cost is low.
Features:
1. The riser sleeve has high strength and is not easy to damage during modeling.
2, heating efficiency and high, insulation effect is very good, long solidification time.
3, the product range is complete, can be suitable for high pressure molding production line conditions.
Scope of application:
The F-200G high heat riser is a self-straightening riser sleeve that can be quickly and safely applied to high pressure molding lines. Combined with the specially designed spring positioning pin and riser core, it can be used for point feeding or in situations where the contact area is smaller.
The following points should be noted in specific use:
1. After calculating the modulus of the feeding casting, select the appropriate riser sleeve, and be sure to make its effective modulus greater than the modulus of the casting.
2, the riser can be used in different embedded or inserted methods. When embedded, a special riser die should be installed on the mold plate.
3, such as supporting the use of easy cutting pieces, must choose the corresponding specification of easy cutting pieces.
Note:
1. The riser sleeve should be stored in a cool and dry place to prevent moisture absorption.
2. Stay away from open flames.
3, do not bake or brush paint on the riser sleeve.
4, packaging, loading and unloading, transportation pay attention to careful handling, to prevent extrusion collision.
Packing requirements:
All kinds of thermal insulation riser sleeves need to be sealed by plastic film, and then strictly packaged in cartons, and can also be packaged according to user requirements.
